Upgrading The Software Using The Cli; Upgrading The Software Using Cvsm - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

Upgrading the Software Using the CLI

Follow these steps to upgrade the module software:
Step 1
Step 2
Step 3
Step 4

Upgrading the Software Using CVSM

To upgrade the module software using CVSM, do the following from the CVSM System
Configuration page:
Note
Step 1
At the switch prompt, change to privileged EXEC mode by entering the enable
command:
Switch> enable
Enter the switch password, if applicable.
Password: <password>
Switch#
Enter the copy command to copy the image in slot 1 or slot 2.
Switch# copy tftp://server//filename slot1:boot
Switch# copy tftp://server//filename slot2:boot
Note When copying the image, Cisco recommends that you overwrite the old
file. This decreases potential problems in the future when you restart the module.
When the module restarts, it uses the first image it finds.
Restart the switch using the reload command:
Switch# reload
To avoid errors during the upgrade process, close all other CVSM pages.
In the Combined Cisco IOS and Visual Switch Manager Upgrade section,
enter the IP address of your TFTP server into the Server IP Address or Name
of TFTP Server field.
Troubleshooting 4-7