Connecting The Cables; Fiber-Optic Cable - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

Connecting the Cables

Connecting the Cables
This section explains how to connect cables to installed ATM modules. Both fiber-optic and
UTP cable connections are discussed.

Fiber-Optic Cable

To connect a fiber-optic cable to the ATM 155 SM-MR or ATM 155 SM-LR module, do the
following:
Step 1
Step 2
Step 3
Figure 2-3
ATM SM-LR Fiber
Tighten
Screws
to Activat e
WS-X2 972-XL
1x
2x
3x 4x
5x
6x 7x
2-6
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
Remove the rubber plugs from the connector on the cable and store the plugs for
future use.
Connect the cable to the connector on the ATM module, as shown in Figure 2-3.
Connect the other end of the fiber-optic cable to the remote ATM device.
Connecting a Fiber-Optic Cable
ATM 155 UTP
Tx
Rx
WS-X2 951-XL
8x
9x 10x
11x
12x 13x
14x
15x 16x
17x
Catal yst 2900
XL
SERIES
Tighten
Screws
to Activat e
Tx
Rx
18x
19x 20x
21x
22x 23x
24x