Configuration Example Procedure - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

•
The 2924M XL switch runs the LEC on ATM interface 1.2 for the emulated LAN
engineering.
•
The VLAN trunk is turned on for Slot A of the 2924M XL switch.

Configuration Example Procedure

To configure the LANE example in Figure C-1, follow these steps:
Step 1
Configure the LECS ATM NSAP address on the LightStream 1010 ATM switch:
Start a session on the Catalyst 5000 ATM module by entering the session
(a)
3 command at the Catalyst 5000 management console:
Console> session 3
Trying ATM-3...
Connected to ATM-3.
Escape character is '^]'.
ATM>
Obtain the default LECS address from the Catalyst 5000 by entering the
(b)
enable and show lane default commands:
ATM> enable
ATM# show lane default
interface ATM0:
LANE Client:
LANE Server:
LANE Bus:
LANE Config Server: 39.000000000000000000000000.00605C28DA23.00
note: ** is the subinterface number byte in hex
ATM#
The default LECS address is
39.000000000000000000000000.00605C28DA23.00.
Configuration Example Procedure
39.000000000000000000000000.00605C28DA20.**
39.000000000000000000000000.00605C28DA21.**
39.000000000000000000000000.00605C28DA22.**
Configuration Examples C-3