Nuova Simonelli Talento Service Manual page 66

L Remove the sleeve from the clock battery
(present only when cpu board is replaced by
a new one);
M Check the position of the red wire in the flat
cable connected to the pcb. It must be on
bottom.
N Check the position of the red wire of the flat
cable in the display. It must be on top.
Further to the left, the door microswitch (O). It
has three states: pushed (when door is closed),
normal when door is open, pulled if engineer
needs to short circuit the door sensor in order to
emulate regular functioning.
6.4
SERVICE MANUAL
Fig. 7
Fig. 8
Fig. 9
M
L
N
O
Edition 02 to 12/2013