Nuova Simonelli Talento Service Manual page 38

1 Correctly position the first worm screw
bearing which is comprised of two wash-
ers with a grooved part inside and the
balls in the centre.
2 Insert the bushing inside the support.
3 Insert the support into the worm screw.
4 Fit the second bearing.
5 Fit the first of the two nut.
Make sure that the movement is correct and
check the clearance of the support.
6 Slide on the not support and tighten with
a 17 mm double wrench
Again make sure that the movement is cor-
rect and check the clearance of the support.
Grease the bearing and bushing with lubri-
cating spray
3.8
SERVICE MANUAL
Fig. 19
Fig. 20
Fig. 21
Edition 02 to 12/2013