Nuova Simonelli Talento Service Manual page 40

On the back of the group chamber is placed
the magnet which closes the microswitch
sensors for the group position.
The back plate of the pouring group contains
the three microswitches for group position-
ing:
A Top position
B Middle position
C Bottom position
Before removing them, mark their position
with a marker pen and then take out each
micromagnetic switch by removing the 2,5
mm screw to free them from the clamps and
using an extractor to take the two pins out
from the wiring connector.
3.10
SERVICE MANUAL
Fig. 25
Fig. 26
Fig. 27
A
B
C
Edition 02 to 12/2013