Nuova Simonelli Talento Service Manual page 19

The machine has a ready-connected 3/4 water
supply pipe.
During initial installation, the service engineer
needs to:
1 Fit a filter to the end of the pipe and connect
this to the water mains (Fig. 9).
2 Make sure that the inlet pressure is <4 bar
and if this is not the case, fit a suitable pres-
sure reducer.
3 Insert a clamp (A) to the drainage pipe and
insert the drainage pipe into the relevant fit-
ting, under the machine.
4 Tighten the pipe clamp firmly and connect
the other end to the drainage outlet.
5 To easily insert the drain pipe, remove the
two screws from the drain conveyer and
move up the machine with two cups. Fix
back the two screws after connected the
pipe.
Edition 02 to 12/2013
SERVICE MANUAL
Fig. 10
Fig. 11
A
Fig. 12
Fig. 13
2
< 4 bar
3
2.5