Nuova Simonelli Talento Service Manual page 56

WARNING
Use a vise to unhook the heating element.
Move the boiler tank to the edge of the vise
and secure it at the lower surface level (weld
joint), to avoid cylinder damage.
11 Securing the boiler in a vise and using
a 37 mm wrench it is possible to loosen
and unscrew the heating element dur-
ing the refitting stages, make sure that
the seal is completely inside the special
seating. Tighten the screw with a 37 mm
wrench.
12 After replacing the coffee boiler heat-
ing element, before switching on the
machine, it's necessary to fill up the
boiler.
BOILER FILLING:
With the machine switched off hold down
both the up and down arrow keys for 8 sec-
onds: display will read "TEST".
1 Press botton;
2 Hold D key to fill the boiler until the water
pours from the coffee nozzle.
For further information see par 12.1
4.8
SERVICE MANUAL
Fig. 23
Fig. 24
11
1
2
Edition 02 to 12/2013