Connecting The Limit Relay Outputs (Option) - Datcon DT4240 Series Operating Instructions Manual

Wiring plan, connecting
the limit relay outputs
(see also "Application
example")
16

5.4. Connecting the limit relay outputs (option).

The following figure shows the wiring plan, connecting the
limit relay outputs:
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
DT4240 xx xx xx xx
20230503-V0