Advertisement
Use the lower slots when anchoring the balancer to the floor. The upper slots are used
to secure the balancer to the shipping pallet.
2. Install a hold-down hook, 216-36, into each of the lower slots.
Only use the lower slots next to each foot. The other slots are for shipping only and
must not be used for attaching floor hold-down hooks.
On wheel lift balancers, one of the three slots is located at the right-front corner,
partially hidden by the brake pedal.
3. Using the three hold-down hooks as templates, mark the drill hole locations. Remove the hold-down hooks
and set aside.
4. Drill three 3/8 inch diameter holes, three inches deep at the locations previously marked.
5. Re-install hold-down hooks into each of the lower slots.
Figure 94
Figure 95
55
Advertisement
