Advertisement
BeLT BReAK-IN
1. Remove the four screws securing the spindle drive belt cover to the base assembly on the right side of the
balancer.
2. Check belt tension as follows:
• The weight tray must be removed from the balancer prior to belt tensioning procedure.
• Position the end of indicator flush with scale of belt tension tool.
• Place index finger inside rubber finger strap of belt tension tool.
• Position the belt tension tool on horizontal section of belt between motor and spindle.
• Push down on belt tension tool until the tool clicks.
• Read belt tension tool where top edge of the arm crosses the scale (refer to illustration).
• Set belt tension to 90 lbs., ± 5 lbs. (40.8 kg ± 2 kg). Check 30 days after installation. Reset if necessary.
SPINDLE DRIVE
BELT COVER
BELT TENSION TOOL
INDICATOR
(25-104-2)
READ SCALE HERE
Figure 70
Figure 71
39
Advertisement
