Advertisement
2. Loosen the nut counter-clockwise until the nut is butted to the adjustment screw (without turning the
adjustment screw).
3. Rotate the adjustment screw clockwise until tight (do not over tighten). Back off the adjustment screw 1/2
turn. This will become the base damper speed for the AutoHood. Once the hood is properly adjusted, the nut
can then be tightened.
4. Locate the inner air valve located on the tub. Verify the symbol located on the valve is pointed towards the
cylinder (O> → cylinder).
5. Perform steps 1 and 2 for the inner air valve. This will become the base raise speed for the AutoHood.
Figure 60
Figure 61
33
Advertisement
