Advertisement
5. Place a 1 1/4 inch open-ended wrench across the flats at the end of the spindle shaft and tighten the spindle
shaft to 50 ft-lbs. (68 N-m).
6. Remove the 3/8 inch bolt and collet from spindle.
7.
Using a 1/4 inch nut driver, tighten the smaller inner hex shaft until snug.
Upon initial start-up, the spindle type in the balancer set up will need to be changed
from threaded shaft (default) to Auto-Clamp for proper operation.
PRY BAR
1 1/4"
WRENCH
SPINDLE
SHAFT
3/8" BOLT
(field supply)
COLLET
Figure 66
INNER HEX
SHAFT
Figure 67
37
Advertisement
