Advertisement
21. Re-install the return spring to the load roller mechanism.
22. Slowly, close the hood. If interference with the hood proximity switch is detected, make the necessary
adjustments now. Refer to "Hood Proximity Switch" on page 42 before equipment damage possibly occurs.
hOOd STOP AdjUSTmeNT
inStall oUter Data Set arm
1. Remove the 3/8-16 X 1/2" socket button head cap screw (SBHCS), 74-93-2, from the shaft portion of the
outer data set arm.
2. Run the single orange banded cable of the outer data set arm through the safety hood shaft.
Figure 52
Figure 53
28
Advertisement
