Advertisement
SPeCIAL TOOLS ReqUIRed
• Silicone or Teflon Grease
• Calibration Tool, 221-672-1 (for Dataset
• Collet (or cone), 1 1/4 inch open-ended wrench and a 3/8-16 X 2 1/2 inch (or longer) bolt (the 3/8 inch
diameter and 16 threads per inch is required) (for spindle installation)
• Torque wrench
The accessories kit contains hardware and loose components that are required to
complete the installation of the balancer.
BASe PLACemeNT
1. Pre-determine a location with the proper floor surface, space, and electrical requirements as stated above
where the balancer will be used.
2. Remove loose components from base assembly and set aside
3. Remove exterior packaging and inspect components.
4. Cut away plastic wrap and packing material. .
Balancers with the optional wheel lift may have a bolt anchoring the balancer to the
pallet located under the wheel lift mechanism.
5. Remove tie strap to free hood bar.
6. Remove the bolts and hold-down brackets securing the base assembly to the pallet.
Retain the hold-down brackets if balancer is to be secured to the floor. The brackets are
used for both shipping and installation.
7.
Remove the base assembly from the pallet.
Use proper lifting techniques when moving the base assembly. Do NOT lift by weight
tray. Two or more people recommended.
®
Arms)
Figure 2
2
Advertisement
