Advertisement
4. Remove rust-preventative paper from within balancer tub. During assembly of balancer, route all external
wires and air lines (if present) through the hole located in back of balancer.
INSTALL dISPLAY SUPPORT ASSemBLY ANd LCd mONITOR
1. Remove support from plastic and align on back left corner. Loosely secure the display support to the base
assembly with four 1/4-20 X 1/2 inch socket button head cap screws, located in accessories kit. Two screws
fasten through the rear of the base assembly and the other two fasten through the side.
2. Incrementally tighten the four screws together to attach the display support to the outside corner of the
balancer.
Figure 7
Figure 8
5
Advertisement
