Advertisement
8. When the calibration is complete, thread the calibration weight into the threaded hole located near the base
of the display support assembly.
9. Place the calibration weight storage decal near the upper right weld nut located on the back of the base
assembly.
INSTALL STORAGe PeGS
Install the lower storage pegs first. This will ease the installation of the upper storage
pegs. If optional side printer storage shelf is to be installed, do not install storage pegs
in the area that the shelf will occupy.
1. Insert the storage peg, into a cutout on the left-hand side of the balancer. Position the peg angled up and
push the peg down into the cutout to lock it into position.
2. Repeat peg installation for remaining pegs.
INSTALL BULLSeYe ™ CeNTeRING SYSTem ANd weIGhT TRAY.
It is recommenced to perform all calibrations and set-up prior to reinstalling weight tray.
Figure 81
47
Advertisement
