Advertisement
Final aDjUStmentS
6. Rotate the adjustment screw counter-clockwise to increase the speed of the hood. The inner valve controls
raise speed while the outer valve controls damper speed. Once proper speed is achieved, rotate the air valve
nut clockwise until tight without turning the adjustment screw. Verify operation after both nuts are secured.
The AutoHood can be tested without powering the machine. With the airline connected, lower the hood
and press the blue button located on the control valve near the inner air valve.
If adjustments are made and no noticeable results are achieved, the air valve could be
mounted in the wrong direction.
two pieCe SpinDle inStallation (international BalanCerS)
1. Install a 3/8-16 X 2 1/2 inch (or longer) bolt through one of the threaded holes in the perimeter of the spindle
face.
2. Insert the end of the spindle shaft with fine internal threads into the spindle assembly.
3. Engage the internal threads of the shaft to threads within the spindle assembly and turn the shaft clockwise
until snug.
4. Place a collet onto the spindle shaft.
5. Insert a pry bar (or tire tool) between the 3/8 inch bolt and collet.
Figure 62
34
Advertisement
