Advertisement
14. Slide the beam forward or backward to center the tire/wheel assembly on the spindle horizontally.
15. When the tire/wheel assembly is centered vertically and horizontally, securely tighten the four bolts attaching
the beam's mounting flange to the attachment blocks.
It may be necessary to remove the tire/wheel assembly from the trolley to move the
beam. However, the mounting position of the beam must be verified with the tire/wheel
assembly in place.
16. Lift the end of the beam slightly when tightening the bolts to close the gap between beam mounting plate and
the attachment blocks.
It may be necessary to remove the tire/wheel assembly from the trolley to move the
beam. However, the mounting position of the beam must be verified with the tire/wheel
assembly in place.
17. To verify proper operation of the wheel lift assembly, remove the tire/wheel assembly from the carrier, raise
the wheel lift, and then close the hood of the balancer. The wheel lift should lower automatically.
INSTALL wheeL LIFT BRACKeT
1. Remove the three button head cap screws, (75-574-2) located behind the rear wheel lift mount.
2. Install the wheel lift bracket (228-85-005) using the three retained button head cap screws, (75-574-2).
INSTALL OPTIONAL BOLT dOwNS
1/2 inch X 2 3/4 inch anchor bolts are not included and must be field supplied.
1. Locate the .25 x 1.12 inch slots next to each foot on the bottom of balancer.
Figure 93
54
Advertisement
