Advertisement
3. Turn "ON" the balancer using the main power switch located on the back of the balancer, near the power
cord.
After the initial start-up, the buttons located on the front of the monitor will typically not
need to be pressed again.
4. Turn "ON" the LCD using the "on/off" button is located on the front of the monitor.
lCD DiSplay monitor SettingS
PLANAR mONITOR
Recommend changing preset picture mode to "Cinema":
1. Press and hold the UP arrow button (3rd button from the left)
2. Use the UP and DOWN arrow buttons on the monitor to locate Cinema
3. Press the #2 button (4th button from the left) to set the highlight present
4. Press the #1 button (1st button from the left) to exit monitor options
Recommend adjusting speaker volume:
1. Press and hold the DOWN arrow button (2nd button from the left)
2. Use the UP and DOWN arrow buttons on the monitor to locate the Volume adjustment
3. Press the #2 button (4th button from the left) to set enable the Volume Adjust
4. Press and hold the UP arrow button until 100% is achieved
5. Press the #1 button (1st button from the left) to exit Volume Adjust
6. Press the #1 button (1st button from the left) to exit monitor options
Figure 73
41
Advertisement
