Advertisement
2. Connect the green audio cable in to the green audio jack on the bottom board.
3. Connect the speaker USB cable to top USB port of the 45-1337-1 board.
4. Cut the supplied Velcro fastener strips (mated loop and hook strips) to fit the appropriate mounting location
on each speaker and the mounting point on (or near) the balancer.
Do not position the speakers where the wires will interfere with any moving part of the
balancer, tire and wheel assemblies or operator movement. After the speakers are
secure, bind the cables with tie straps to prevent possible movement.
5. Remove the protective film from the Velco loop and hook strips and attach to the speakers and mounting
points. Secure the speakers to the mounting points.
Figure 25
Figure 26
15
Advertisement
