Table of Contents
Advertisement
16 - 23 Nm
17 - Oil drain plug, 30 Nm
❑ Renew bolt if it has a captive seal
18 - Sump
❑ Removing and installing
19 - Oil level and oil temperature sender - G266-
20 - 12 Nm
21 - Baffle plate
22 - 8 Nm
❑ Apply locking fluid "D 000 600 A2" when installing
23 - Seal
❑ Renew
❑ Lubricate before installing.
24 - Oil filter housing / left engine bracket
❑ Dismantling and assembling
❑ Coolant hose schematic diagram
❑ Right engine bracket and specified torque
25 - 23 Nm
1.2.1
Removing and installing oil spray jet
Special tools and workshop equipment required
♦ 4 mm ∅ drift
♦ 6 mm ∅ drift
Note
Oil spray jets are installed in main bearings 2...7.
Removing
– Press oil spray jet out towards bearing using a 4 mm ∅ drift.
Installing
– To install, press oil spray jet in to correct installation position
by hand using a 6 mm ∅ drift -arrow-.
⇒ page 101
⇒ page 98
⇒ page 114
.
⇒ page 25
6-cylinder injection engine - Edition 02.2014
Phaeton 2003 ➤
1. Parts of lubrication system
97
Advertisement
Table of Contents
