Table of Contents
Advertisement
Phaeton 2003 ➤
6-cylinder injection engine - Edition 02.2014
– Fit puller - T10095 A- from flat side of connector in direction of
arrow and pull out ignition coil with output stage (cyl. 1...6).
– Remove intake hose between air mass meter - G70- and
throttle valve module - J338- .
– Pull 6-pin connector off throttle valve module - J338- as well
as 2-pin connector off activated charcoal filter system solenoid
valve 1 - N80- and crankcase breather valve.
– Now pull activated charcoal filter system solenoid valve 1 -
N80- with bracket off intake manifold support.
– Pull all vacuum connections -arrow- off intake manifold and
unscrew securing bolt -1- of intake manifold support.
– Now unscrew intake manifold supports on left and right of in‐
take manifold.
– Disconnect crankcase breather hose at cylinder head cover.
70
Rep. gr.15 - Cylinder head, valve gear
Advertisement
Table of Contents
