Preparation For Use - Otto Bock 17B105 Series Instructions For Use Manual

► Prior to thermal treatment, remove all temperature-critical components
(such as plastic parts).
NOTICE
Exposure of the product to unsuitable environmental conditions
Damage, brittleness or destruction due to improper handling
► Avoid storage in condensing ambient humidity.
► Avoid contact with abrasive substances (e.g. sand, dust).
► Do not expose the product to temperatures below -10 °C (14 °F) or
above +60 °C (140 °F) (e.g. sauna, excessive sunlight, drying on a
radiator).

5 Preparation for use

NOTICE
Orthotic joints not aligned in parallel
Malfunction of the locking mechanism
► Use the 743R6 orthotic joint alignment fixture.
► Make sure the orthotic joints lock simultaneously in the extension stop.
Use the following connecting elements for the insertion zones:
Side bars
Lamination joint bars
Shaping the bars
1) Secure the bars on the orthotic joint using the screws and check the
alignment on the model.
2) Mark the insertion zone on the bar.
3) Loosen the screws of the bars and adapt the bars with bending irons.
4) Fasten the shaped bars to the orthotic joint using the screws.
5) Repeat the steps until the desired result is obtained.
Using the lamination dummy
For bar
width
16 mm
17B38=*, 17B39=*, 17B40=*, 17B41=*,
17B84=*, 17B85=*
17Y128=*, 17Y129=*
Required materials
Lamination Lamination
dummy bar
17Y126=16 17Y128=16*
17Y129=L16/
=R16
Alignment Shoulder
insert screw
17Y128=* 501A1=10x7­
xM4
15