After-Season Maintenance And Storing; Restarting The Machine After Longer Storing Periods - SaMASZ UNO 410 Operator's Manual

lubricate the PTO shaft tubes with STP grease,
if necessary, lubricate the other parts and assemblies in accordance with the lubrication
instructions (Section 7).

6.3. After-season maintenance and storing

At the end of the season the following shall be performed:
lower the rake's rotor onto the ground,
take the PTO shaft extension out of the tractor rpm or dismount the complete PTO shaft and install it into
corresponding holder at the 3-point linkage frame,
unmount electrical cables from the tractor and hang them onto corresponding holders on the 3-point
linkage frame,
disconnect the rake from the tractor (reverse procedure as in case of attaching the rake to the tractor
Section 5.1), and then drive the tractor away.
Rake should be stored in standstill position, so it is supported onto supporting leg. It is
recommended to store the set on paved ground, preferably in roofed places, inaccessible to
unauthorized personnel or animals. If the machine is exposed to weather conditions, apply
lubrication regularly.
If the rake is stored for a long period of time before first operation, check its technical
condition and pay special attention to the hydraulics and the drive. Paint the area where the
paintwork is damaged.
Additionally:
remove any traces of rust and paint the area,
check the oil level in the drives (Section 7). If leaks are found, remove them immediately and refill the
oil. If water in the oil is found, immediately change the oil as the water could cause corrosion of internal
mechanisms such as gear wheels, bearings, or shafts, and cause breakdowns,
periodically inspect the rake and lubricate its moving parts in order to protect them from corrosion which
has adverse effects on the proper operation of the rake,
check hydraulic hoses regularly. Replace any damaged or old hoses. In any case, you should replace
hoses that have been in use more than 5 years from the date of their manufacture printed on the hose.

6.3.1. Restarting the machine after longer storing periods

After longer storing period do the following:
Make sure that all nuts and screws are tightened with correct torque (
Make sure that all guards are installed in place,
Lubricate the whole machine,
Check pressure in tires.
Tab. 4. Torque values for bolts
Operator's manual
- 24 -
Rotary rake UNO
),
Tab. 4