3. Adding Paper, Toner and Staples
3
Loading Paper into the Twin Interposer
This section describes how to load paper into the twin interposer.
• Load paper on the side already printed (the front side). If you are using the Booklet Finisher (Saddle
Stitch), load sheets print side down.
• Load paper in the twin interposer in the same orientation as paper in the paper tray.
• The staple or punching location will be on the left side of the paper, when you are facing the machine.
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly scanned or paper jams.
• When using the Z-fold function, the paper in the twin interposer must be of the same size as the prints
after they have been Z-folded. If the paper in the twin interposer is larger than the Z-folded sheets, a
misfeed might occur.
• Each tray can hold up to 200 sheets of paper. Do not stack paper over the limit mark.
1.
While pressing the release lever, align the side fences with the paper size to be loaded.
50
BAZ024S
BTD400S