Ricoh Pro C550EX Operating Instructions And Troubleshooting page 51

• Load paper on the side already printed (the front side). If you are using the Booklet Finisher (Saddle
Stitch), load sheets print side down.
• Load paper in the interposer in the same orientation as paper in the paper tray.
• The staple or punching location will be on the left side of the paper, when you are facing the machine.
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly scanned or paper jams.
• When using the Z-fold function, the paper in the interposer must be the same size as the prints after
they have been Z-folded. If the paper in the interposer is larger than the Z-folded sheets, a misfeed
might occur.
• The tray can hold up to 200 sheets of paper. Do not stack paper over the limit mark.
1. Load paper orderly.
2. Adjust the side fences to the paper size.
• To set the paper in the interposer, align the orientation of originals in the ADF as shown below.
BAY029S
BAY030S
Loading Paper
3
49