Ricoh Pro C550EX Operating Instructions And Troubleshooting page 35

Problem
Copy paper becomes
creased.
Copy paper becomes
creased.
Copies are not stapled.
Copies are not stapled.
Copies are stapled as
separate batches.
Staples are wrongly
positioned.
Paper does not output during
printing with stapling.
Saddle-stitched documents
come apart and do not stack
properly.
You cannot combine several
functions.
When sorting, the pages are
divided into two blocks.
Cause
The paper is damp.
The paper is too thin.
There are jammed staples in
the stapler.
Copy paper is curled.
The number of copies is too
great for the stapler to staple
as a single batch.
Originals are not set
correctly.
When you stop printing while
using the staple function,
paper not stapled during
printing may be left in the
staple unit.
Certain types of paper are
resistant to folding and open
out after being folded and
stitched.
Selected functions cannot be
used together.
The memory became full in
the middle of sorting and the
pages were delivered in two
blocks.
When You Cannot Make Copies As Wanted
Solution
Use paper that has been stored in the
recommended temperature and
humidity condition. See "Paper
Storage", About This Machine.
Use recommended paper. See
"Recommended Paper Sizes and
Types", About This Machine.
Remove jammed staples. See p.92
"Removing Jammed Staples".
Turn the copy paper over in the tray.
Check the stapler capacity. See
"Supplementary Information", Copy/
Document Server Reference.
Check the correct position to place the
originals. For details about how to place
originals with stapling, see "Staple",
Copy/Document Server Reference.
Press the [Clear Modes] key and cancel
copy settings, including stapling.
Use recommended paper. See
"Recommended Paper Sizes and
Types", About This Machine.
Check the combination of functions and
make the settings again. See "Function
Compatibility", Copy/Document
Server Reference.
In [Copier / Document Server Features],
under [Input/Output], set [Memory Full
Auto Scan Restart] to [Off].
2
33