3. Adding Paper, Toner and Staples
This chapter describes troubleshooting procedures that are applicable to all the machine's functions.
Loading Paper
This section describes what to do when paper runs out and needs reloading.
• When loading paper, take care not to trap or injure your fingers.
1
Tray 1 and LCT use 8
/
2
• Fan the paper before loading.
• Straighten curled or warped paper before loading.
• If you want to load paper other than 8
representative.
• For details about paper sizes and types, see "Recommended Paper Sizes and Types", About This
Machine.
• To load paper in the bypass tray, see "Copying from the Bypass Tray", Copy/Document Server
Reference.
Loading Paper into Tray 1 (Tandem Tray)
This section describes how to load paper into tray 1.
• When paper loaded in the right side of tray 1 runs out, paper on the left is automatically shifted to
the right. While the paper is moving, a message instructing you to wait appears. Do not pull out the
tray at this time.
• You can load paper even while making copies from tray 1. You can pull out the left side of tray 1
while copying is in.
• For the right side of tray 1, align the right edge of the paper with the right edge of the tray. For the
left side of tray 1, align the left edge of the paper with the left edge of the tray.
1
• Tray 1 uses 8
/
× 11 paper. If you want to load A4 paper, contact your service representative.
2
• Each tray can hold up to 1,100 sheets of paper. Do not stack paper over the limit mark.
× 11 exclusively. Load only 8
1
/
× 11 paper in tray 1 or LCT, contact your service
2
1
/
× 11 paper at all times.
2
3
43