Ricoh Pro C550EX Operating Instructions And Troubleshooting page 23

Problem
Misfeeds occur frequently.
Misfeeds occur frequently.
Cannot print in duplex mode. Duplex printing cannot be
Cannot print in duplex mode. [Apply Duplex] is set to [No]
Cannot print in duplex mode. You cannot select duplex
• If you cannot make copies as you want because of paper type, paper size, or paper capacity
problems, use recommended paper. See "Recommended Paper Sizes and Types", About This
Machine.
• Using curled paper often causes misfeeds, soiled paper edges, or slipped positions while performing
staple or stack printing. When using curled paper, take the stiffness out of the paper with your hands
to straighten out the curl, or load the paper up side down. Also, to prevent paper from curling, lay
paper on a flat surface, and do not lean it against the wall.
Cause
There is a foreign object on
the finisher tray.
The staple cartridge is not set
correctly.
done with paper set in the
bypass tray.
for "Paper Type: Tray 1-3".
printing if the paper type is set
to [Tab Stock].
When You Have Problems Operating the Machine
Solution
• Remove the misfed paper. See
p.71 "Removing Jammed
Paper".
• Do not place anything on the
finisher tray. It may cause a paper
jam.
Set the staple cartridge properly. The
Finisher SR4020 requires the saddle
stitch staple cartridge also. For details
about how to add staples, see p.67
"Adding Staples".
When using duplex printing, make
settings to use paper from a tray other
than the bypass tray.
In [Tray Paper Settings], under "Paper
Type: Tray 1-3", set [Apply Duplex] to
[Yes].
In [Tray Paper Settings], under "Paper
Type: Tray 2-3", select a paper type
other than [Tab Stock].
1
21