Adding Paper, Toner And Staples; Loading Paper; Loading Paper Into Tray 1 (Tandem Tray) - Ricoh Aficio MP 5500 Operating Instructions Manual

5. Adding Paper, Toner
This chapter explains troubleshooting procedures that are applicable to all the
machine's functions.

Loading Paper

This section explains what to do when paper runs out and needs reloading.
R CAUTION:
• When loading paper, take care not to trap or injure your fingers.
Tray 1 use letter size (8
per at all times.
Note
❒ Fan the paper before loading.
❒ Straighten curled or warped paper before loading.
❒ If you want to load paper other then letter size paper in Tray 1, contact your
service representative.
❒ For paper types and sizes, see "Recommended Paper Sizes and Types",
About This Machine.
❒ To load paper in the bypass tray, see "Using the Bypass Tray", Copy/Docu-
ment Server Reference.

Loading Paper into Tray 1 (Tandem Tray)

The following procedure explains loading paper into Tray 1.
Important
❒ When paper loaded in the right side of Tray 1 runs out, paper on the left is
automatically shifted to the right. While the paper is moving, a message in-
structing you to wait appears. Do not pull out the tray at this time.
❒ For the right stack, align the right edge of the copy paper with the right edge
of the tray. For the left stack, align the left edge of the copy paper to the left
edge of the tray.
❒ Tray 1 uses only letter size (8
other then letter size paper, contact your service representative.
❒ Do not stack paper over the limit mark.
" × 11"K) paper exclusively. Load only letter size pa-
1
/
2
" × 11"K) paper. If you want to load paper
1
/
2
and Staples
65