Table of Contents
Advertisement
5. Rotate the adjuster foot by hand until the feet of the basic storage system contact the floor, and
completely ground them on the floor.
6. Install tentatively the washers and hexagon nuts (20) that are supplied with the extension console, in
the screwed portions of the four adjuster feet. (Tighten them at the four positions.)
7. Rotate the four adjuster feet by 180d in the direction of the arrow using an open-end wrench.
8. Tighten finally the four hexagon nuts (20) with the four washers that are tentatively tightened in step
6. (Use the open-end wrench of diagonal size: 30 mm.)
4-16
Hexagon nut (20)
Washer
Hexagonal bolt
block
Adjuster foot
CSM-200
Advertisement
Table of Contents
