Table of Contents
Advertisement
3. Check that height of point [A] is 275 mm above the floor. If height of point [A] is not 275 mm, adjust
height as follows. Loosen the four nuts of the respective casters with open-end wrench. Adjust height
of the respective casters with hexagon Allen wrench (diagonal size: 10 mm). (One full clockwise
rotation of a caster by 360d raises the console by 2.5 mm. Counter-clockwise rotation of a caster by
360d lowers the console by 2.5 mm.)
4. Place a level on the portions [B] and [C], and check that the basic storage system is level. If the basic
storage system is not level, adjust height of the casters until it is level.)
Allen wrench (10 mm)
Height from the floor level is 275 mm.
CSM-200
M20
N20
Caster
[A]
The bubble in the level must stay in the
center of the internal gauge lines.
[C]
[B]
Bubble
4-15
Advertisement
Table of Contents
