Table of Contents
Advertisement
[When the drive reflector plate base type 2 is used]
Drive reflector plate base (Type2)
(4) Remove the two screws. Remove the first drive reflector plate base in the direction of the arrow. To
remove the first drive reflector plate base, remove it in the way of removing the one protruded portion
in the top of the first drive reflector plate base, from the slits as shown.
(5) Remove the second drive reflector plate base in the same procedure as step (4).
Drive reflector
plate base
(type2)
(6) Install the first drive reflector plate base so that the reflector plate faces toward the rear side.
Install the reflector plate of the first drive reflector plate in the way that the protruded portions a and b
of the first drive reflector plate base fit the corresponding slits, and tighten the screws c and d tenta-
tively. Then tighten the screws c and d finally in this order.
n
Install the drive reflector plates starting from the bottom stage.
(c) PWH4 x 8
(7) Install the second drive reflector base following the same procedure as described in step (6).
4-120
Projection
Slit
PWH
4 x 8
Slit
a
reflector plate
Drive
reflector
plate base
b
(type2)
Slit
(d) PWH4 x 8
Drive reflector
plate base (type2)
CSM-200
Advertisement
Table of Contents
