Storage - Gastroback DESIGN MINCER PLUS Operating Instructions Manual

STORAGE

WARNING!
unplug and clean the appliance and all its parts before storing (see: ›Care and
Cleaning‹).
Ensure to store the appliance where it is clean, dry and safe from frost, direct sunlight
and inadmissible strain (mechanical or electric shock, heat, moisture) and where it is
out of reach of young children. Place the appliance on a clean and stable surface,
where it cannot fall. Do not place any hard or heavy objects on the appliance or
any part of it.
Always handle the power cord with care. Power cords may never be knotted, twis-
ted, pulled, strained or squeezed.
Do not use any parts or tools of the appliance for any other purpose than operating
the appliance. It is a good advice to store the parts and accessories of the appliance
with the appliance.
1. Always clean the appliance and its parts before storage (see: ›Care and
cleaning‹).
2. It is good a advice to reassemble the cutter housing with cutter blade and a grin-
ding disc before storage, (See: ›Assembling the appliance‹) to avoid injuries by
the cutter blade.
3. Additionally, you can insert some tools in the pusher (see picture Q). For this,
remove the cover of the pusher and place the tools into the interior, as shown in
the figure. Then insert the pusher in the feed tube of the cutter housing.
4.
Carefully roll up the power cord without knotting or bending it. Then place the power cord
in the cord compartment in the bottom of the motor housing.
CAUTION:
the motor housing, always grasp it at both sides near the bottom.
5. Grasp the motor housing with both hands at its sides, and place it and all parts
and tools on a suitable surface, where it cannot fall, and is out of reach of young
children.
58
Always switch off completely (ON/OFF button and power switch),
Do not carry the appliance by the tray or cutter housing. To move