Overheat Protection; Care And Cleaning; Disassembling The Appliance - Gastroback DESIGN MINCER PLUS Operating Instructions Manual

If the motor gets stuck again or reverse operation does not work, switch off the appli-
ance completely (ON/OFF button), unplug and clean the appliance according to the
instructions in chapter ›Care and cleaning‹. However, if the problem persists, slow
down working and cut your foods to smaller pieces, before processing in the mincer.

OVERHEAT PROTECTION

This appliance is equipped with an overheat protection that will automatically shut off
the appliance in case of overheating.
s ›Power switch / overheat protection‹.
the instruction
Slow down your work-speed and use smaller portions. Regularly, switch off the appli-
ance in between times for 15 minutes. Please contact you vendor or an authorized
service centre, if the overheat protection is activated too often, anyhow.

CARE AND CLEANING

WARNING!
or outlet of the cutter housing, while the appliance is connected to the power supply.
The cutter blade is sharp-edged. Handle with care to avoid cutting your fingers.
Do not place or immerse the motor housing or power cord in water or any other
liquids. Do not spill any liquids on the motor housing or power cord. Do not pour any
liquids in the feed tube, while the cutter housing is assembled to the motor housing.
Always disconnect the cutter housing from the motor housing, before assembling or
disassembling any tools or removing stubborn blockages.
Do not place the appliance or any part of it in an automatic dishwasher.
Do not leave any food dry up on the appliance or any parts of it to prevent a build
up of dried-on foods. Always clean the appliance after each use according to the
following instructions.

DISASSEMBLING THE APPLIANCE

WARNING!
until the motor comes to complete standstill, and unplug from power outlet, before
disassembling or cleaning the appliance.
1. Switch off the ON/OFF button and power switch, wait until the motor comes to
complete standstill, and unplug from power outlet.
2. Remove the pusher. Then lift the tablet upwards to remove it.
56
Do not insert your hands or any foreign objects in the feed tube
Always switch off the ON/OFF button and power switch, wait
If your appliance suddenly stops running act upon