Control Panel; Fig. 9 Adapting The Control Panel - Otto Bock B400 Instructions For Use Manual

6.1.3 Control Panel

NOTICE
Cable damage. Positioning the cable incorrectly can lead
to pinching and thus damage to the cable. The cable must
not be attached too tightly or too loosely. Avoid bending or
squeezing the cable.
INFORMATION
Later changing of the control panel's mounting position
from the left to the right side or vice versa may only be
carried out by specialist dealers.
Adapting the Control Panel to Arm Length
To adapt the control panel to the arm length of the user, you
must loosen the three screws on the underside of the arm-
rest using a 3 mm Allen wrench (see fig. 9). You can now
slide the control panel backwards and forwards.
B400
Fig. 9 Adapting the control panel
Firmly re-tighten the screws after making adjustments.
If the control panel rail is too long, the protruding
INFORMATION
part can simply be cut off with a saw.
Operation
Ottobock 27
|