Setting Up The System Management Module (Smm) Network Connection - Intel R2600SR Series Setup And Service Manual

Complete the following steps to connect the BMC to the network:
1. Start the system.
2. When <F1> Setup appears, press F1.
3. Specify how the BMC will connect to the network.
a. If choosing a static IP connection, specify an IPv4 or IPv6 address available on the network.
b. If choosing a DHCP connection, make sure the MAC address for the system has been configured in
the DHCP server.
4. Click OK to continue configuring the system.
2.3.2

Setting Up the System Management Module (SMM) Network Connection

The SMM web interface can be accessed through an Ethernet connection (10/100/1000 Mbit) by establishing
a session with the SMM.
Connecting to the SMM for the first time may require a change of the Internet protocol properties on the
client computer.
To log into the SMM web interface, complete the following steps:
1. By default, the SMM network is disabled. Enable the SMM network by issuing the enable IPMI
command below to the BMC Controller. The <XCC IP> is the XCC IP address:
Enable
ipmitool -I lanplus -H <XCC's IP> -U USERID -P PASSW0RD raw 0x3A 0xF1 0x01
2. The following two commands can also be used to either query or disable the SMM network.
Query
ipmitool -I lanplus -H <XCC's IP> -U USERID -P PASSW0RD raw 0x3A 0xF1 0x00
Disable
ipmitool -I lanplus -H <XCC's IP> -U USERID -P PASSW0RD raw 0x3A 0xF1 0x02
18
Intel® Server System R2600SR Setup and Service Guide