Configure Chassis Triggers
Chassis trigger signals are routed using the interactive Trigger Routing Diagram. Refer to
the section titled Triggers and Timing Signal Definition for a description of available signals.
Refer to the section titled
trigger routing pages.
Configure Internal Trigger Source
This procedure provides instructions to configure a Chassis to use an internal signal as a
trigger source.
How to Configure Internal Trigger Source
1
Navigate to the Trigger Routing Matrix page.
–
2
Select the
Diagrams page.
3
Enable the Signal Relay Switch for the desired TRIGn (0:11) to the desired TRIGn
(0:11).
Configure External Trigger Source
This procedure explains how to configure a Chassis to use an external signal as a trigger
source.
How to Configure External Trigger Source
1
Connect a valid signal source to Chassis Trigger Input Connector.
2
Navigate to the Trigger Routing Matrix page of the Chassis Web UI
–
3
Select the
Diagrams page.
4
Enable the Signal Relay Switch for EXT_TRIG_IN to the desired TRIGn (0:11).
5
Return to the Trigger Diagrams page. Select the
External Trigger
6
Configure the System Trigger Threshold.
Rev. D0
May 2020
"Trigger Routing Diagram"
Access: Main Menu > Trigger Diagrams
Click to Configure Trigger Routing Matrix
Access: Main Menu > Trigger Diagrams
Click to Configure Trigger Routing Matrix
box from the Trigger Diagrams page.
mA-1302/mA-1305 AXIe Chassis Operation Manual
Chapter 5 mA-1302/mA-1305 Control and Operation
on page 4-12 for a description of
box from the Trigger
box from the Trigger
Click to Configure Trigger
Configure Chassis Triggers
Page 5-19