Table of Contents
Advertisement
Chapter 4 Chassis Web User Interface (UI)
Web UI Pages
Self Test Page
The Self Test Page accesses the Chassis Self Test procedures. The Chassis Self Test is
an automated process that evaluates the Chassis' operational status to verify the following:
•
Verifies Chassis temperature and power readings are within tolerance;
•
Verifies Chassis fan speeds are operating above minimum tolerance;
•
Checks for presence of an internal frequency reference and verifies the internal
frequency reference is within tolerance;
•
Checks for the presence of trigger signal and verifies signal is within threshold;
•
Checks for the presence of a host controller module and verifies module temperature
and voltage readings are within tolerance.
•
Verifies communication and data exchange (when applicable) between Chassis
Backplane, Chassis Modules and Chassis data I/O ports.
Figure 4-13
Self Test status is updated throughout the procedure: green indicates a test has passed;
red indicates a test has failed (as shown in the example below).
Refer to the section titled
Chassis Self Test.
Page 4-22
Chassis Self Test Page
"Self Test Procedure" on page 6-7
mA-1302/mA-1305 AXIe Chassis Operation Manual
for instructions for running the
Rev. D0
April 2020
Advertisement
Table of Contents
