Table of Contents
Advertisement
7
The Chassis Networking page displays the IP address for each module in the
system.
Figure 5-7
How to Reset the Chassis IP Address
Scope of Procedure
This procedure applies to mA-1305 Chassis running software 1.2.0 or higher.
This procedure is used to recover and reset the Chassis IP Address when the IP
Address is unknown.
NOTE
To ensure that all steps are performed properly, read this procedure in its entirety before
performing this procedure.
Restore Chassis Default IP
1
Connect one end of an Ethernet cable to the host controller.
2
Connect the other end of the Ethernet cable to one of the Ethernet connectors on the
CMP System.
3
Navigate to the host controller's network settings window; record the host controller's
network settings for use later in this procedure.
4
Set the host controller's IP to the Chassis Recovery IP Address (169.254.11.11).
5
Set the host controller's Netmask to 255.0.0.0.
6
Power cycle (reboot) the Chassis.
Rev. D0
May 2020
Chassis Web UI Networking Page
mA-1302/mA-1305 AXIe Chassis Operation Manual
Chapter 5 mA-1302/mA-1305 Control and Operation
Configure Network Connections
Page 5-15
Advertisement
Table of Contents
