Table of Contents
Advertisement
Remove Module
CAUTION
Modules are ESD sensitive and should only be installed, removed and/or serviced by
Qualified Service Personnel.
Mise en Garde
Les modules sont sensibles aux DES et ils doivent seulement être installés, enlevés ou
entretenus par du personnel de service qualifié.
CAUTION
Do not operate the Chassis with empty slots. Install Filler modules in empty slots to
ensure proper airflow through the Chassis.
Mise en Garde
N'utilisez pas le châssis avec des fentes vides. Installez des modules de remplissage
dans les fentes vides afin d'assurer un écoulement d'air adéquat dans le châssis.
How to Remove a Module
1
Power down the Chassis.
2
Fully loosen the captive screws on each side of the module.
3
Grasp the module Securing Latches and pull the Latches outwards and away from
the module to disconnect the module from the Backplane Connectors.
4
Pull until the Securing Latches are at a 90° angle with the front of the module. See
Figure 3-3 on page
5
Grasp the module and pull to remove the module from the Chassis.
NOTE
If the Module is being returned to the manufacturer, refer to the Module's user
documentation for packaging and shipping instructions.
Rev. D0
May 2020
3-10.
mA-1302/mA-1305 AXIe Chassis Operation Manual
Chapter 3 mA-1302/mA-1305 Setup and Installation
Module Installation
Page 3-11
Advertisement
Table of Contents
