Table of Contents
Advertisement
Chapter 3 mA-1302/mA-1305 Setup and Installation
Module Installation
Module Installation
The AXIe Chassis supports AXIe compliant modules. The Chassis is configured so that
modules are interchangeable and are not slot specific.
NOTE
When installing modules, refer to the user documentation provided with the module for
special instructions or connection requirements. As mentioned above, the Chassis is
not slot-specific, however, module user documentation may contain other important
installation requirements.
If an Embedded Host Module is being used in the Chassis, install the host module in the
Chassis before proceeding with this section. Refer to the Module's user documentation
for safety, installation and operating information.
CAUTION
Modules are ESD sensitive and should only be installed, removed and/or serviced by
Qualified Service Personnel.
Mise en Garde
Les modules sont sensibles aux DES et ils doivent seulement être installés, enlevés ou
entretenus par du personnel de service qualifié.
CAUTION
Modules are not "hot -swappable." The Chassis must be powered down before installing
or removing modules from the Chassis.
Mise en Garde
Les modules ne peuvent pas être « changés lorsque sous tension. » Le châssis doit être
mis hors tension avant d'installer ou d'enlever des modules du châssis.
CAUTION
Use care when installing modules to avoid damaging any modules already installed in the
Chassis.
Mise en Garde
Faites attention lors de l'installation de modules afin d'éviter d'endommager les modules
déjà installés dans le châssis.
Page 3-8
mA-1302/mA-1305 AXIe Chassis Operation Manual
Rev. D0
April 2020
Advertisement
Table of Contents
