Powering The Chassis; Power On The Chassis; Power Off The Chassis - Viavi mA-1302 Operation Manual

Powering the Chassis

Power on the Chassis

This section describes how to power on the Chassis.
NOTE
If the Chassis is connected to a External Host Controller via a PCIe Connection, the
External Host Controller should be off before powering on the Chassis.
How to turn on the Chassis
1 Complete Chassis setup and installation (refer to
page
2 Press and release the Chassis On/Standby Button to initiate the power up process.
Verify the Chassis On/Standby Button LED flashes green.
3 Wait while the Chassis runs the Self Test Procedure.
4 The Chassis On/Standby Button LED stays green when the power up process is
complete.

Power off the Chassis

This procedure should be used to routinely power down the Chassis. In the event the
Chassis is in an unresponsive state perform a "Forced Power Down".
How to turn off the Chassis
1 Press and release the Chassis Power On/Standby Button to initiate the power down
process. The Chassis Power On/Standby Button LED flashes amber.
2
Wait while the Chassis completes the power down process.
3 The Chassis On/Standby Button LED turns amber when the power down process is
complete.
Rev. D0
May 2020
3-5).
mA-1302/mA-1305 AXIe Chassis Operation Manual
Chapter 5 mA-1302/mA-1305 Control and Operation
"Setting up the Hardware" on

Powering the Chassis

Page 5-3