Connecting To Power Supply - Viavi mA-1302 Operation Manual

About this Manual

Connecting to Power Supply

Connect all peripheral equipment (i.e., External Host Controller) before connecting the
Chassis to an AC power supply.
Grounded AC Power Supply
The Chassis should only be connected to a grounded AC Power Supply using the AC
Power Cord included with the Chassis, or an appropriate replacement.
Class II, Ungrounded 2-Terminal Socket
To connect the Chassis to a Class II (ungrounded) 2-terminal socket outlet, fit the power
cord with either a 3-pin Class I plug used in conjunction with an adapter incorporating a
ground wire, or fit the power cord with a Class II plug containing an integral ground wire.
The ground wire must be securely fastened to ground; grounding one terminal on a
2-terminal socket does not provide adequate protection.
NOTE
For use in Switzerland, Type 12 Plug should be used to connect the Chassis to a
grounded power supply.
Power Cord Requirements
Use the AC Power Cord included with the Chassis to connect the Chassis to a grounded
AC power supply. If the AC Power Cord that was shipped with the Chassis is not available,
a replacement AC power cord that meets local regulations and power requirements may
be used. Check with local standards and regulations to ensure the power cord being used
meets all local safety regulations.
Power cords must be in good operating condition. Power cords must not be frayed or
broken, nor expose bare wiring. Using a damaged power cord may expose the operator to
hazardous voltage levels.
Preface - viii
mA-1302/mA-1305 AXIe Chassis Operation Manual Rev. D0
May 2020