Table of Contents
Advertisement
Procedure
This section explains how to sync each mA-3011 ("root device") to instrument trays ("target
hardware" in the Chassis. Refer to
needed to reference hardware slot locations.
1
Power on the Chassis.
2
Open a browser window.
3
Enter the Chassis IP address in the browser URL field.
4
Navigate to the Chassis Management page.
5
Select Root menu: Select Slot 1 (location of the mA-3011 Dual Embedded Host).
6
Select the Advanced Config Button.
7
Go to the Saved Configuration section of the PCIe Domains page.
Figure C-3
8
Set the following Endpoint parameters for Domain 0.
a
b
c
9
Press the Add Endpoint button.
Rev. D0
May 2020
PCIe Saved Configuration Settings Example
Known Device: Manual
Slot: Slot 3
Device: 1
mA-1302/mA-1305 AXIe Chassis Operation Manual
Appendix C PCIe (Slot) Configuration Procedure
"System Hardware Configuration" on page C-4
PCIe Configuration Procedure
when
Page C-5
Advertisement
Table of Contents
