Table of Contents
Advertisement
Chapter 3 mA-1302/mA-1305 Setup and Installation
Upon Receipt
Upon Receipt
The procedures outlined in this section should be performed when the Chassis is received
from the factory.
Unpack the Chassis
Special design packing material provides maximum protection for the Chassis. Avoid
damaging the shipping container and packing material when unpacking equipment; if
necessary the shipping container and packing material can be reused to ship the Chassis.
CAUTION
This Device is ESD sensitive and should only be unpacked by qualified personnel.
Mise en Garde
Cet appareil est sensible aux DES et il doit seulement être déballé par un personnel
qualifié.
How to Unpack the Chassis
1
Cut and remove sealing tape on top of shipping container.
2
Open shipping container and remove top packing mold.
3
Remove Chassis from bottom packing mold.
4
Remove Chassis from protective ESD packaging.
5
Store packing material and shipping container for possible future use.
Inspect Equipment
Inspect the Device for possible damage incurred during shipment. Report any damage to
VIAVI Customer Service.
Verify Contents
Refer to packing list to verify shipment is complete. Report any discrepancies to VIAVI
Customer Service.
NOTE
A Chassis that ships from the factory with modules installed in the instrument slots will
include Filler Modules with the shipment. Store Filler Module(s) for future use. Refer to
the section titled
Page 3-4
"Module Installation" on page 3-8
mA-1302/mA-1305 AXIe Chassis Operation Manual
for additional information.
Rev. D0
April 2020
Advertisement
Table of Contents
