Table of Contents
Advertisement
Chassis Networking Page
NOTE
The Chassis ships from the factory with an assigned Static IP Address. Do not
connect the Chassis to your local area network (LAN) without contacting your IT
department to determine if the Chassis' default IP Address is already in use. If the
Chassis' default IP Address is already in use by a device on the network, connecting
the Chassis to the network will cause a network conflict.
It is recommended that the Chassis be reconfigured to use a Static IP address assigned
by your IT department before connecting the Chassis to a LAN.
The Chassis Rear Transition Module (RTM) provides standard 10/100/1000 Base-T
Ethernet connectivity via an RJ-45 Connector for LAN Network connectivity.
The Chassis Networking Page identifies CMP system IP Addresses and is used to
configure the system's network connectivity. This section provides a general overview of
the controls and settings found on the Chassis Networking page.
Refer to
important network configuration information as well as procedures for resetting or locating
system IP Addresses.
Figure 4-10
Rev. D0
May 2020
"Configure Network Connections" on page 5-9
Chassis Networking Page
mA-1302/mA-1305 AXIe Chassis Operation Manual
Chapter 4 Chassis Web User Interface (UI)
for detailed instructions and
Web UI Pages
Page 4-17
Advertisement
Table of Contents
