Table of Contents
Advertisement
Chapter 3 mA-1302/mA-1305 Setup and Installation
Hardware requirements
Hardware requirements
The Chassis is controlled by a Host Controller. The Host Controller can be an Embedded
Host Module such as the mA-3011 AXIe Embedded Host Module or the host controller can
be an External Host Controller such as a computer or tablet.
Network Caution Statement
NOTE
The Chassis ships from the factory with an assigned Static IP Address. Do not
connect the Chassis to your local area network (LAN) without contacting your IT
department to determine if the Chassis' default IP Address is already in use. If the
Chassis' default IP Address is already in use by a device on the network, connecting
the Chassis to the network will cause a network conflict.
It is recommended that the Chassis be reconfigured to use a Static IP address assigned
by your IT department before connecting the Chassis to a LAN.
Embedded Host Module
The Chassis can be controlled using the mA-3011 AXIe Embedded Host Module or
another AXIe Embedded Host Controller.
If an mA-3011 AXIe Embedded Host Module was purchased together with the Chassis, the
Host Module was installed in the Chassis prior to shipment.
If an Embedded Host Module is being installed in the Chassis after the Chassis has been
shipped from the factory, refer to the documentation included with the module, or refer to
the section in this manual titled
Figure 3-1
Page 3-2
"Module Installation" on page 3-8
mA-3011 AXIe Embedded Host Module
mA-1302/mA-1305 AXIe Chassis Operation Manual
for instructions.
Rev. D0
April 2020
Advertisement
Table of Contents
