Table of Contents
Advertisement
Setting up the Hardware
Setting up a Chassis consists of several stages. Each stage contains different procedures
depending on the following factors:
•
The type of environment in which the Chassis will be operated (bench top or rack
mount).
•
The type of host controller that will be used.
Procedure Overview
The AXIe Chassis setup instructions are presented in a format which is intended to guide
users through the process of setting up a new Chassis System. If you are reconfiguring an
existing AXIe Chassis System, refer to the appropriate procedures in this section.
Step 1: Receive Chassis from the Factory
When the Chassis is received from the factory, complete the procedures in the
following sections to verify shipment and Chassis operation:
–
–
–
Step 2: Install Chassis in Work Environment
The Chassis is designed for bench top or rack mount use. Refer to the following
sections for Chassis installation instructions.
–
–
Step 3. Install Modules (if applicable)
If applicable, install Embedded Host Module or instrument modules in the Chassis.
Step 4: Connect External Host Controller
If applicable, refer to one of the following procedures to connect the Chassis to an
External Host Controller.
–
–
–
–
Step 5: Install Software on Host Controller
Refer to the documentation provided with the Host Controller for information about
installing or updating software.
Rev. D0
May 2020
Upon Receipt
Initial Setup Procedure (Chassis)
Verify Chassis Operation
Bench Top Use
Rack Mount Use
Desktop PCIe Connection Procedure
Laptop PCIe Connection Procedure
External Host Controller Wired LAN Connection Procedure
External Host Controller WiFi Connection
mA-1302/mA-1305 AXIe Chassis Operation Manual
Chapter 3 mA-1302/mA-1305 Setup and Installation
Setting up the Hardware
Page 3-5
Advertisement
Table of Contents
